Introduction
The network settings are configured through the CM1-T Configuration Tool application which connects to the USB on the back of the motor. This application also allows you to read the currently configured settings.
The following network parameters are available in the tool:
| Parameter | Read/Write | Description |
|---|---|---|
| Firmware Version | Read | Current CM1-T firmware version |
| MAC Address | Read | MAC address of the CM1-T |
| Current IP Address | Read | The IP address that the CM1-T is currently using |
| DHCP Enabled | Read/Write | Indicates whether the CM1-T should use DHCP or a static IP |
| IP Address | Read/Write | IP address if DHCP is not enabled |
| Default Gateway | Read/Write | Default gateway if DHCP is not enabled |
| Subnet Mask | Read/Write | Subnet mask if DHCP is not enabled |
| CML Socket Type | Read/Write | Socket type TCP or UDP |
| CML Socket Port # | Read/Write | Port # for CML connection. Typically 10001 |
| Modbus Socket Type | Read/Write | Socket type TCP or UDP |
| Modbus Socket Port # | Read/Write | Port # for Modbus-TCP connection. Typically 502 |
GUI
Setting Static IP
Communications Log
Connection Settings
Download
Download the CM1-T Configuration Tool Here: LINK GOES HERE
Overview
Content Tools