Versions Compared

Old Version 54

changes.mady.by.user Mark McCann

Saved on

compared with

New Version 55

changes.mady.by.user Mark McCann

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

This section explains how to use the CM1-T Cool Muscle motor with EtherNet/IP. It is assumed there is a basic knowledge of EtherNet/IP and PLC programming. The implementation makes use of the different Modes Of Operation Direct Control in the motor. It does not use CML logic and bank programming. However, setup (K) and controller gain (H) parameters are used for things like motor resolution, s-curve, software limits, etc. These are all accessible to be setup with Control Room or over explicit messages.

...

This section focuses on controlling the motor with the provided Add on Instructions (AOIs). These will satisfy most applications, however, if required, the motor can be controlled by setting the CM1-T objects directly (see I/O Messages). Understanding the Modes Of Operation Direct Control will be important in this case.

...