Page History

...

Ethernet Connectors

The Ethernet IN and OUT ports use standard Ethernet RJ45 CAT5e, M8-A or M8-D connectors depending on the motor variant. They are labeled IN and OUT but either port may be used.

Image Removed

The CM1-T Ethernet connections will act as a TCP/IP switch, allowing multiple . Multiple motors or other devices to can be connected in a daisy chain configuration without the need to run a separate ethernet connection back to a central demarcation for each motor. switch for each ethernet device.

Connector Options

• RJ45
  Image Added

  • Amphenol - RJHSE538B02

• M8-A Female
  Image Added

  • TE Connectivity - T4041017041-000‎
• M8-D Female

Pinout

^{(1) Pins 4,5,7 and 8 are connected to GND.}

Example Cables

All ethernet cables are standard pinouts and are available from a variety of online suppliers or cable houses. Here are a few example cables from the Phoenix Contact NBC series

Power Connector

The power connector supplies 24V to the TCP/IP slave and the motor separately. These two can be tied together so both are off the same power supply.

...